UTx318

UTx318 equipped with a 4000mAh undetachable battery. It can last at least 8 hours after fully charged.

Note: Results are obtained from lab test data, actual performance might vary from different usage scenarios.

Sure, thermal tracking is supported on UTx318. Long press magnification button to activate thermal tracking when the device is on. A rectangle icon will show on the monitor, and the hottest area will be automatically located.

Total 5 palettes available on UTx318, including Black Hot, White Hot, Red Hot, Iron Red, and Rainbow. Press the button with M character to switch palettes when the device is on.

UTx318 is an infrared thermal monocular, only Thermal mode is available.

Of course. UTx318 supports 2x and 4x magnification. Short press magnification button to adjust zoom multiple when the device is on.

Focal length of UTx318 lens is 18mm, and its aperture is F1.0. 13.5mm and 25mm lens are also suitable for UTx318.

There are 3 calibration modes available on UTx318, including Background calibration, Shutter calibration, and Auto calibration.

Background calibration:

• FunctionInstruction: In some special usage scenarios, imaging quality will be weakened when there are much difference between operating temperature and ambient temperature, and it cannot be well compensated by shutter calibration. In this case, background calibration is a best choice.
• Principle: Put a uniform surface in front of the movement during calibration to ensure the uniform radiation can be collected by the detector, and then detector focal plane array is homogenized;
• Operation steps: Enter Settings menu by long pressing Palette button, selecting Background calibration by touching Zooming button and “Shutter”, Short press Palette button to confirm. Covers the lens, then short press Palette button again to calibrate background;

Shutter calibration:

• Function Instruction: Optimize imaging effect by compensating lights.
• Principle: Add a shutter plate into the internal of the equipment during calibrating, which ensures that the detector focal plane array collects uniform radiation of the shutter plate
• Operation step: Short press Power button to calibrate shutter when the device is on. Shutter will be closed automatically during calibrating. Press Power button again to finish calibration.

Auto Calibration:

• Automatically calibrate camera parameters based on software algorithm, and correct imaging effect.

①Close the lid of lens to avoid the dust attached to the lens or heavy light directly illuminate the lens when you do not need to use the device;

②Manually adjust diopter wheel and Focus wheel until thermal imaging clearly display during shooting;

③Do not plug out MCX connectivity cable directly when Video Format is activated;

④Do not use laser light to aim at eyes to avoid damaging;

⑤Use wet cloth or weak soap fluid to clear body case, do not use abrasive, isopropyl alcohol or solvent to clean the lens/windows;

⑥Store the device in a dry, non-corrosive environment, avoid sunshine directly illuminate.